Newsletter Sign-up Form:



Required for human verification. Enter the
code as shown in the image below.


X  CLOSE

Request a Free copy of the Edging Handbook:

             
  

                    
  

                  
  

                  
  

                        
  

                  
  


Required for human verification. Enter the
code as shown in the image below.


   


X  CLOSE
Home | About Us | Products | Installation & Tips | Upcoming Events | FAQ | Contact Us
Product Fast Find:
Install to proper depth
EDG-KING OVERLAP METHOD    See the how-to video - click here
1. Cut off a 4” section of the round bead at the top of one of the edging pieces with a metal snip, utility knife or saw.
2. Use the connector that comes with the edging to join the two sections. Overlapping the two pieces of edging.
3. Drive the steel anchoring stake through both sections at a 45 degree angle toward the turf or outside portion of the bed.


BLACK EDG-KNIGHT OVERLAP METHOD
1. Cut off a 4” section of the round bead on one of the edging pieces and a 4” section of both v-lips on the other piece with a metal snip, utility knife or saw
2. Use the connector that comes with the edging to join the two sections. Overlapping the two pieces of edging.
3. Drive the steel anchoring stake through both sections at a 45 degree angle toward the turf or outside portion of the bed.


BLACK JACK OVERLAP METHOD    See the how-to video - click here
1. Cut off a 4” section of the round bead on one of the edging pieces and a 4” section of the v-lip on the other piece with a metal snip, utility knife or saw.
2. Use the connector that comes with the edging to join the two sections. Overlapping the two pieces of edging.
3. Drive the steel anchoring stake through both sections at a 45 degree angle toward the turf or outside portion of the bed.


TRIM-LINE OVERLAP METHOD
1. Cut off a 4” section of the round bead on one of the edging pieces and a 4” section of the v-lip on the other piece with a metal snip, utility knife or saw.
2. Use the connector that comes with the edging to join the two sections. Overlapping the two pieces of edging.
3. Drive the steel anchoring stake through both sections at a 45 degree angle toward the turf or outside portion of the bed.


SLIM-EDG OVERLAP METHOD
1. Cut off a 4” section of the top of one of the edging pieces, just below the bottom bead, with a metal snip, utility knife or saw.
2. Use the connector that comes with the edging to join the two sections. Overlapping the two pieces of edging.
3. Drive the steel anchoring stake through both sections at a 45 degree angle toward the turf or outside portion of the bed.


SUPER-EDG CONNECT METHOD
1. Using a hacksaw, cut both pieces of edging leaving a stake slot 3” from the end. Apply PVC cement to both sides of the edging, front and back.
2. Use the connecting H-clip that comes with the edging to join the two sections. Do this quickly before the glue sets.
3. Drive the 14” steel anchoring stake through both sections using the pre-cut slots until the stake cannot go any deeper.


© Copyright 2011   Oly-Ola Edgings, Inc. All Rights Reserved zip

E-mail: edgings@olyola.com | Privacy Policy | Site design by Chicago Web House


Home | About Us | FAQs | Landscape Edgings | Paver Restraints | Low-profile Edgings | Contact Us